Mosaic solid lubricant bearing corrosion prevention method

Tweet

Judgment standard and the important degree, mechanical properties and control depends on the cycle, such as the following bearing damaged, need to change don't reuse. Using the Mosaic solid lubricant bearing lubrication process is very important. If you use a grease metamorphism play should not only a little, and to damage the bearings. The butter and tangle between thumb and repeated massage the finger better butter hand feel oily without friction between abrasive dust, finger feeling more sand or attrition, suggests that oil impurities, more discomfort, a new oil should be replaced. Supplier Of SKF 6206 Bearing on the racecourse voice and audio path management method when Mosaic solid lubricant rolling element bearing, its travel path plane rolling, how smooth continuous rolling bearing, all major sound unique voice. General bearing voice is the voice of the racecourse, combined with other sounds. Ball bearing, the racecourse sound is wrong, the 1000 hz frequency is higher, it is not really the main frequency and the speed of change, but the total sound pressure level increases, accelerate the turnover. The racecourse voice big bearing, lawn audio sound pressure level to reduce the viscosity of growth path; Sound small bearings, the sound pressure level increasing viscosity is about more than 20 was/s. Big pillow hardness, lawn acoustics, the lower the total sound pressure level. As the radial clearance is too small, the total sound pressure level and the main lawn acoustics frequency will increase as the radial clearance decreased sharply. Sound management path selection methods are: low noise bearings, namely small waveform bearing conditions of use, choose carefully. The sound part of the racecourse, reduce machine noise acoustic path can reduce the mechanical noise. The reason of corrosion: As a result of the bearing is bearing corrosion phenomenon of all internal and external factors also more and more, the main reasons are as follows: 6 hours 1, bearing materials is the chemical composition and structure of the metal. 2, poor and metal surface finish the oxygen concentration cell corrosion. 3, bearings and other metal surface contact. 4, all kinds of metal bearing surface contact environment. 5, bearing temperature and humidity of the environmental impact. 6, some juice and cause bearing corrosion, pH 5 ~ 6. So in order to prevent hand and cause corrosion of equipment and the production, should put gloves, hand to contact solid inlaid bearing lubrication. Preventive measures: In order to prevent corrosion, can make the bearing of preventive measures. They can apply anti-rust oil to prevent rust on it. The following three methods of painting. 1, the method with a layer of anti-rust grease on the bearing surface adhesion method. For some small bearing anti-rust oil, soak them in the oil film thickness control in temperature or grease antirust viscosity. 2, the method of use: paint besmear brushs evenly, pay attention to in the Mosaic solid lubricant bearing surface, had better not to packaging, and prevent leak, pay attention to. 3, method of use: for some large spraying antirust materials not by soaking, spray paint solvent XiShiXing rust-proof oil or thin layer of anti-rust oil. Note, however, that this method should be used fully and fire safety measures.